Oscillators Menu; Psu Status Menu; Version Menu - digico DQ-Rack User Manual

DQ & MQ-Rack User Guide

Oscillators Menu........................................................................

In the Oscillators menu, the user can apply the rack's internal oscillator signal all output sockets. To enable the
oscillator, select the out option, hold the right button down and a bar next to the word OFF will begin to fill,
when the bar fills, the word will change to ON and signal will be applied to all 24 outputs.
From within the Oscillators menu one of 8 frequencies can be selected between 20Hz and 20KHz, on default
settings the frequency is set to 1KHz.
The level of the oscillator can also be changed to be a range of volumes between a value of -96dB and 0dB, at
default setting the level is -96dB.

PSU Status Menu .........................................................................

The PSU Status menu page shows readings for all rack PSU voltages. No adjustments are possible from this
menu.

Version Menu .................................................

The Version menu page shows the software versions of the Host and FPGA currently installed in the rack.
No adjustments are possible from this menu.
On the DQ-Rack there are additional versions displayed, for the DNT and Dante software versions.
MQ-Rack version menu
DQ-Rack version menu
1.5 Using the Q-Rack Menu System
13