Activating Instrument Sections - Clavia Nord Stage User Manual

Nord Stage v3.1x
E P
DITING A
Actually, how to change a programmed sound can be described in one sentence: "tweak the knobs
and press the buttons". It is as simple as that! Don't be afraid to edit and overwrite the factory Pro-
grams. If you want to restore any of the original factory programs later, you can download them at
http://www.clavia.se and transfer them to your Nord Stage as MIDI SysEx files. To indicate that a
Program has been edited (changed from the stored version), an asterisk is shown to the right of the
Program number in the D
R
EVERTING TO THE ORIGINAL
If you have edited a Program and want to revert to the stored original, just press the corresponding
P button again.
ROGRAM
S
TORING AND
How to store and name Programs is described in a separate chapter - see
page 16.
A
CTIVATING INSTRUMENT SECTIONS
There are three main instrument sections in Nord Stage: the Organ section, the
Piano section and the Synth section. You can activate/deactivate instrument
sections in the following ways:
• Pressing the KB Z
that one or more of the LEDs lights up will activate the corresponding instrument. If all LEDs are
lit, the instrument will play across the whole range of the keyboard. Any other active instrument(s)
will in this case be layered with the instrument you just activated.
• Pressing the KB Z
will turn off the corresponding section.
• For information on how to use splits see the chapter
page 56.
I
NSTRUMENT
Alternatively, you can use the following method to select one of four basic I
(Init-Organ/Init-Split Organ/Init-Piano/Init-Synth). This will activate the corresponding instrument,
and deactivate all other instruments.
1. Hold down the S
2. Press one of the O
activate the corresponding instrument section. The "Split Organ" setup uses a split for a Lower/
Upper manual organ where the lower half of the keyboard plays an organ belonging to Panel A
and the upper half plays Panel B (see
ROGRAM
.
ISPLAY
N P
AMING ROGRAMS
S O /O
ONE ELECT N
S button for an active Instrument section (so that the LEDs go dark)
ONE ELECT
I
NITS
button.
HIFT
, S O
RGAN PLIT RGAN
4. Getting Started: Activating instrument sections
P
ROGRAM
button for an Instrument section so
FF
"Keyboard Zones and Dual Panel setups" on
, P S
IANO OR YNTH
"About Split Organ Setups" on page
"The Program section" on
NSTRUMENT
buttons in the Program section to
29).
I setups
NIT
Page 13