Table of Contents
Advertisement
3.
IN-SERVICE INSPECTION & MAINTENANCE
INITIAL INSPECTION
Check that the correct Trolley and the capacity of lifting equipment attached to
the Trolley are suitable for the job in hand. Prior to using the Trolley for the first
time, it must be checked by a competent person. Visually check that the Trolley
has been delivered and/or stored in a safe and undamaged condition.
IN-SERVICE INSPECTION – Before operation
Prior to starting work check the Trolley and load bearing constructions, visually
for any defects. It is the operator's responsibility to ensure that all load bearing
constructions are suitable to carry the Trolley and the load attached to the Trolley
BEAM CLAMP INSPECTION
Visually inspect the Trolley for wear, defects, and deformations or
superficial/corrosion marks before use. If operator is unsure of the condition, they
should be checked by a trained and competent person.
LOAD BAR INSPECTION
Visually inspect the Trolley to determine that the load bar has been assembled
correctly. The Load bar should also be checked for wear, defects, and
deformations or superficial/corrosion marks before every use.
The Load Bar must also be checked to make sure it is in the vertical position,
relevant to the beam the trolley is fitted on.
Advertisement
Table of Contents
