Table of Contents
Advertisement
5.
OPEARTION
Both the geared and push travel trolley have been designed to move along
traversing beam using all four running wheels.
The Push Travel Trolley can be operated by gently and safely pushing the load
along the beam by hand (once the load has been lifted off the floor),
The Geared Travel Trolley can be operated by using the hand chain provided –
by pulling down clockwise the trolley will start to move to the right, by pulling
anticlockwise the trolley will travel to the left.
NEVER push or pull a load which is attached to a trolley while it is still situated on
the ground.
6.
MAINTENANCE/INSPECTION
To maintain continuous and satisfactory operation, a regular inspection
procedure must be initiated so that worn or damaged parts can be replaced
before they become unsafe. The intervals of inspection must be determined by
the individual application and are based upon the type of service to which the
Trolley is subjected.
The Trolley should be visually inspected by the operator / competent person daily
or before each use.
Annual inspection, repairs and re-certifying of the Beam Clamp should be carried
out in accordance to European Safety Regulations – therefore the hoist must be
returned to a recognized and competent lifting equipment repair centre.
7.
TROUBLE SHOOTING
If the trolley is not moving in the correct manor – i.e. not running smooth check
the beam is clear of all obstacles, check that all wheels are running smoothly,
check wheels to determine that they have not become damaged, check the
trolley is seated correctly on the beam and to the correct clearance
Advertisement
Table of Contents
