Advertisement
3 - IN SERVICE INSPECTION & MAINTENANCE
INITIAL INSPECTION
Check that the correct hoist and the capacity of hoist are suitable for the job in hand.
Prior to operating hoist for the first time, the hoist must be checked by a competent
person. Visually check hoist has been delivered and/or stored in a safe and undamaged
condition.
IN-SERVICE INSPECTION – Before operation
Prior to operating hoist check all components are free from excessive wear and general
condition of hoist is good. Inspect the housing, chain and hooks are all in good working
condition. If hoist is fitted with brake it should be tested before operation. Check that
anchor point is sufficient to take the intended load.
LOAD CHAIN INSPECTION
The Load Chain should be inspected for wear, defects, and deformations or
superficial/corrosion marks before use, if operator is unsure of condition of chain it
should be checked by a trained and competent person. Clean and lubricate at regular
intervals.
CHAIN STOP INSPECTION
Check that the chain stop is fitted securely to one link of chain only.
TOP/BOTTOM HOOK INSPECTION
Both the top and bottom hooks should be inspected for wear, defects, and deformations
or superficial/corrosion marks before use. Check that safety catches are fitted and are
working correctly if operator is unsure of condition of hooks, they should be checked by
a trained and competent person.
- 3 -
Advertisement
