natus Bio-logic NavPRO ONE Quick Start Manual page 6

Bio-logic NavPRO ONE
®
If you are using an ear probe, a calibration will be performed together with the impedance check.
You can select the simple calibration or the expert calibration mode in the device set up.
Note: the probe can only be used for low stimulus intensity testing.
Simple calibration mode
ASSR test screen
Progress for each
tested frequency
Overall EEG, – value should remain in
the lower third. Press to enable raw
®
EEG view
Test progress
Stop test Pause ongoing test
Expert calibration mode
Frequency being tested
Intensity level being tested
Impedance monitor
Skip this single test
6
QUICK START GUIDE