HAMPTON BAY 252-575 Instruction Manual page 6

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
2ea Lock Nuts (#2) 3ea Wire Connectors (#16)
1ea Ground Screw (#18) 2ea Outlet Box Screws (#19)
INSTALLATION INSTRUCTIONS:
1. Screw the two Mounting Screws (#20) onto the Cross Bar (#17). Mount the Cross Bar
(#17) to the Outlet Box (#15) using the two Outlet Box Screws (#19). [Make sure the
threads of the Mounting Screws (#20) are facing outside when the Cross Bar (#17) is
attached to the Outlet Box (#15).]
2. Wrap the ground wire from the fixture around the Ground Screw (#18) on the Cross Bar
(#17), and then connect the ground wire from the fixture to the ground wire from the
Outlet Box (#15). Connect the white wire from the fixture to the white wire (neutral wire)
from the Outlet Box (#15). Connect the black wire from the fixture to the black wire (live
wire) from the Outlet Box (#15). Cover the three connections using the three Wire
Connectors (#16). Wrap the three wire connections with electrical tape for a more secure
connection. Position the wires back inside the Outlet Box (#15). Note: If you have
electrical questions, consult your local electrical code for approved grounding methods.
3. Place the fixture body on the wall by aligning the protruding Mounting Screws (#20)
through the appropriate holes on the Wall Plate (#1). Tighten the fixture to the wall by
screwing the two Lock Nuts (#2) onto the two protruding Mounting Screws (#20).
4. Once the fixture is mounted on the wall, caulk the space between the wall and the upper
3/4 area of the Wall Plate (#1) to prevent water seeping into the Outlet Box (#15). Leave
the bottom 1/4 area uncaulked for drainage of any water which might leak into the
enclosure.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.
Page 6
1ea Cross Bar (#17)
2ea Mounting Screws (#20)
AVERTISSEMENT:
1. Avant de commencer à installer ce luminaire ou d'enlever l'ancien luminaire,
déconnectez le courant en éteignant le disjoncteur ou en enlevant le fusible
correspondant du coffret à fusibles.
2. CONSULTER UN ELECTRICIEN
QUESTION RELATIVE A L'ELECTRICITE.
3. En cas de questions non relatives à l'électricité à propos de ce luminaire,
veuillez contacter notre centre de Service à la Clientèle au 1-877-527-0313
ou visiter www.homedepot.com. Veuillez indiquer votre UGS (252-575
luminaire cuivre antique, 252-577 luminaire cuivre poli) ou UPC
(725916821876 luminaire cuivre antique, 725916821883 luminaire cuivre
poli).
4. Conserver votre reçu et ces Instructions comme Preuve d'Achat.
OUTILS REQUIS POUR L'ASSEMBLAGE & L'INSTALLATION
(non inclus):
Ampoule Lunettes de Protection
(100 watts maxima)
(ou équivalent LFC)
Tournevis à Tête Plate Tournevis à Croisillon
QUALIFIE POUR
Echelle Gants Dénudeur de Câbles
Electriques
Ruban Adhésif Pince pour Joint en Caoutchouc Silicone
Isolant Cables Electriques un usage extérieur
TOUTE
Page 19