How To Remove Remaining Paper; Removing Paper Jam - Citizen iDP-3310 User Manual

4.5 How to Remove Remaining Paper

(1) In case of paper end, keep pressing FEED switch, and pull out the paper if the paper is not feeded.
(2) In case the paper is still remaining open the printer cover and then cut the paper completely with manual
cutter on the upper cover, after that feed out the paper with pressing FEED switch.
CAUTION :

4.6 Removing Paper Jam

Carry out the following procedure to remove paper jam.
Make sure to Turn OFF the power switch before this procedure.
(1) Turn off the power switch and open the printer cover.
(2) Cut the paper completely with manual cutter on the upper cover.
(3) Remove the paper completely. Pull out the paper carefully, do not pull out roughly.
Do not give damage the print head when handling.
(4) Turn on the power switch if the paper is completely removed.
CAUTION :
Be sure to use the FEED switch for pulling out paper.
Do not pull out the paper strongly for any directions, if it is needed, pull the paper
quietly.
Since print head and motor are hot, do not carry out this action right after printing.
Do not carry out this action while printer is turned on.
When removeing the remaining paper, do not touch the surface of heating unit of the
print head by bear hands or by a metal piece etc. This may cause a problem.
Do not feed the paper with FEED switch if the print head is not positioned on the left
side of carridge rail. It will be positioned on the left side by turning on the power
switch again.
Do not touch the manual cutter while removing the paper.
14
iDP3310 User's Manual
CITIZEN