Kreg Straight Edge Guide Owner's Manual page 12

Table of Contents

Advertisement

Available languages

Available languages

2
Position the Guide Rail and Cutline Indicator Arms
a. Position the guide on your material with the guide rail with the GripMaxx
(C) flush to the far edge of the material. Tilt and slide the adjustable GripMaxx
clamp (E) and slide it to align flush to the near edge of the material.
Note
When the adjustable GripMaxx
move in the guide rail. When it is tilted at 90° it will stop and not move.
b. Slide the cutline indicator arms (F) outward until the indicator stops (G) are
against the clamps. Align the flat face of the arms to your measured marks.
Note
Be sure to align both the near and far cutline indicator arms (F) to your
measured marks.
3
Clamp the Straight Edge Guide in Place on Your Material
With both indicator arms aligned to their marks, clamp the straight edge guide in
place. Press against the middle of the adjustable GripMaxx
while using your other hand to pull the handle (H) towards you.
12
F
G
E
clamp (E) is tilted at an angle, it will travel and
C
E
clamp (E) with one hand
H
clamp

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Straight Edge Guide and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents