Raider RDI-EP14 User Manual page 10

10 www.raider.bg
9. Inclusion and exclusion.
Beware of the voltage of supply network! Tension of the supply network must comply with the details shown on the plate of power.
Appliances marked with 230 V, can be supplied with a voltage of 220 V.
9.1. To turn on the power plane, press and hold precautionary button against accidental inclusion . Then press the trigger switch .
Exclusion plane release trigger switch .
10. Working with electrical plane.
10.1. Where possible, work with a small force of pressure. The mass of the power is sufficient to achieve good performance. Excessive
increases the power of the press does not increase productivity and leads to a drastic drop in speed, excessive heating of engine damage
to the work piece and the elements of the plane.
10.2. Bevel edges.
Cut in the middle of the front based on the plane "V" - shaped channel facilitates rapid processing of the edges of the material being
processed. Place the base with "V"-shaped channel on the edge of the processed material and move the plane forward. The processing
of the edges holds the plane at an angle of 450. Do not throw the tool and do not overload.
Keep and refer to the accessories carefully.
Make periodic breaks at work.
11. Service and Support.
11.1. Never use water or any chemical liquid to clean the electrical plane. It should be cleaned with a piece of dry tissue, and accumulated
dust removed with a soft brush. Always store the plane in a dry place and keep the vent on the hull clean.
11.2. Replacing the carbon brushes. Exports (shorter than 5 mm), up or broken carbon brushes of the engine should be replaced. Always
replace both the two brushes. Work on replacement of carbon brushes entrusted only to qualified person with original spare parts in
company service of RAIDER.
11.3. The repair of your power is best carried out only by qualified professionals repairers of RAIDER, which used only original spare parts.
Thus it ensuring their safe operation.
12. Preservation of the environment.
In view of environmental power, additional accessories and packaging must be subjected to appropriate processing for reuse of the
information contained in these materials.
Do not dispose of electric household waste! Under the EU Directive 2012/19/EC on waste electrical and electronic devices and validation
and as a national law power which can be used more, must be collected separately and be subjected to appropriate processing for
recovery of contained they scrap.