Download Print this page

Daikin EKBMSMBA Installation Manual

Advertisement

Quick Links

INSTALLATION MANUAL
Gateway
EKBMSMBA
EKBMSBNA

Advertisement

loading

Summary of Contents for Daikin EKBMSMBA

  • Page 1 INSTALLATION MANUAL Gateway EKBMSMBA EKBMSBNA...
  • Page 2 Gateway Serial module µ chiller compact...
  • Page 3: Description Of The Gateway

    IF UNSURE OF INSTALLATION PROCEDURES OR USE, ALWAYS CONTACT YOUR DAIKIN DEALER FOR ADVICE AND INFORMATION. NTRODUCTION Thank you for purchasing the Gateway EKBMSMBA or EKBMSBNA Kit. This Gateway will enable you to communicate Purpose with your chiller or chillers through a Building Management System (BMS) or other supervisory system.
  • Page 4 Dimensions Tighten the nuts of the cover and make sure the chassis is grounded again. NSTALL THE ATEWAY Do not install the Gateway near power cables or radio- transmitting sources. e w a G a t When manipulating internal jumpers, do not touch the electronic components with your fingers in order to prevent stray currents which could irreparably damage the 105.4...
  • Page 5: Hardware Configuration

    Connections of the Gateway to the configuration Connections to make for a cable with two 9-pole female connectors. Make the connections as listed: computer Supervisory system Gateway (connector labelled 'modem') The connection of the configuration computer to the Gateway is 9-pole female 9-pole female made to the 9-pole male connector at the back of the Gateway...
  • Page 6 12C BUS OPTION (MS-DOS How to enable the output communication RS-485 at OFTWARE CONFIGURATION PROGRAM the ‘RS-422/485’ port Installation of the configuration software for the You can only enable output communication RS-485 when jumper Gateway A is in position 2-3. System requirements for the PC to configure the Gateway: The table shows the position of the jumper and the possibility in BACnet and Modbus-Jbus.
  • Page 7 Parameter list means the sequence of parameter selection with If you only digit rdbaccnf (for BACnet) or writemb0 without the following syntax: parameters or if some parameter is not defined, the program will display the correct syntax to be used again. parameter list = <com>...
  • Page 8 4PWE08535-1 Zandvoordestraat 300, B-8400 Oostende, Belgium...

This manual is also suitable for:

Ekbmsbna