Noises - AEG SKE81226ZF User Manual

12 www.aeg.com
Problem
Water flows inside the refrig‐
erator.
Temperature cannot be set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.

9. NOISES

There are some sounds during normal running (compressor, refrigerant circulation).
Possible cause
Food products prevent the
water to flow into the water
collector.
The "Coolmatic function" is
switched on.
The appliance is in demon‐
stration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' temper‐
ature is too high.
Many food products are
stored at the same time.
The door has been opened
often.
The "Coolmatic function" is
switched on.
There is no cold air circula‐
tion in the appliance.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
Make sure that food products
do not touch the rear plate.
Switch off "Coolmatic function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "Coolmatic function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tempera‐
ture decrease to room temper‐
ature before storage.
Add less food products at the
same time.
Open the door only if necessa‐
ry.
Refer to "Coolmatic function".
Make sure that there is cold air
circulation in the appliance.