Chapter 2: Product Overview; Srw2048; Front Panel; Leds - Cisco SRW2016 User Manual

Chapter 2
Chapter 2:
Product Overview

SRW2048

Front Panel

The Switch's LEDs and ports are located on the front
panel.
Front Panel of the SRW2048

LEDs

POWER (Green) Lights up green to indicate
that power is being supplied to the Switch.
LINK/ACT (1-48)
green to indicate a functional 10/100-Mbps
network link through the corresponding port (1
through 48) with an attached device. It flashes
to indicate that the Switch is actively sending
or receiving data over that port. Lights up
amber to indicate a 1000-Mbps connection on
the corresponding port (1 through 48) with an
attached device. It flashes to indicate that the
Switch is actively sending or receiving data over
that port.
ETHERNET 1-48 The Switch is equipped with
48 auto-sensing, Ethernet network ports, which
use RJ-45 connectors. The Fast Ethernet ports
support network speeds of 10 Mbps, 100 Mbps,
or 1000 Mbps. They can operate in half and
full-duplex modes. Auto-sensing technology
enables each port to automatically detect the
speed of the device connected to it (10 Mbps,
100 Mbps, or 1000 Mbps), and adjust its speed
and duplex accordingly.
WebView Switches
(Green/Amber) Lights up
MiniGBIC (1-4) The miniGBIC (gigabit interface
converter) port is a connection point for a
miniGBIC expansion module, so the Switch can
be uplinked via fiber to another switch. The
MiniGBIC port provides a link to a high-speed
network segment or individual workstation at
speeds of up to 1000 Mbps.
Use the Linksys MGBT1, MGBSX1, or MGBLH1
miniGBIC modules with the Switch. The
MGBSX1 and the MGBLH1 require fiber cabling
with LC connectors, while the MGBT1 requires
a Category 5e Ethernet cable with an RJ-45
connector.
NOTE: On the SRW2048, MiniGBIC ports are
shared with standard ports. If a miniGBIC port
is used, then the shared standard port on the
Switch cannot be used. The following table
provides port mapping details of the SRW2048
Switch.
SRW2048 Shared Port Mapping
miniGBIC Port Standard Port
miniGBIC 1 Port 23
miniGBIC 2 Port 24
miniGBIC 3 Port 47
miniGBIC 4 Port 48

Back Panel

The power port is located on the back panel of the
Switch.
Back Panel of the SRW2048
POWER The Power port is where you will
connect the AC power.
Product Overview
2