Port Management > Link Aggregation; Link Aggregation > Detail - Cisco SRW2016 User Manual

Chapter 5
PVE When a port is a Private VLAN Edge (PVE) port,
it bypasses the Forwarding Database and forwards all
unicast, multicast, and broadcast traffic to an uplink.
NOTE: All ports in the same PVE group should
join the same VLAN group.
LAG
(Read-only) The LAG to which this port belongs, if
the port is a LAG member.
Click Save to save the settings and leave the screen open.
Click Save & Close to save the settings and close the
screen. Click Close to close the screen without saving the
settings.
Port Management > Link Aggregation
Port Management > Link Aggregation
LAG The LAG number (1-8).
Description The user-defined description for the LAG.
Admin Status The administrative status of the LAG. Up
indicates that the LAG is available. Down indicates that
administrator has taken the port offline. When modifying
the option, click Save Settings.
Type Indicates if a LAG has been manually configured
(static) or dynamically set through LACP.
Link Status
Displays the status of the link.
Speed
Displays the port speed.
Duplex
Displays the duplex mode.
Flow Control
Displays the flow control status of the LAG.
It is active when the port uses Full Duplex Mode.
LAG Mode Displays the LAG status: On, Off, or Not
Present.
Detail To create a new LAG, click Detail in the Detail
column to display the Link Aggregation detail screen.
WebView Switches
Advanced Configuration
Link Aggregation > Detail
Link Aggregation > Detail
LAG Configuration
LAG The LAG number (1-8). To display or edit another
LAG, select the number from the drop-down menu.
Description The user-defined LAG description of up to
64 characters. This field is blank by default.
LACP
Select the checkbox to enable Link Aggregation
Control Protocol (LACP).
LAG Type (Read-only) The LAG type.
Administrative Status The LAG's administrative status.
Select either Up or Down to enable or disable the LAG.
Current Status (Read-only) The LAG's status, either Up or
Down.
Reactivate Suspended LAG
suspended, select this checkbox to reactivate the LAG.
Operational Status (Read-only) Displays whether the
LAG is operational or non-operational.
Admin Auto Negotiation
Negotiation on the LAG. Auto-negotiation is a protocol
between two link partners that enables a LAG to advertise
its transmission rate, duplex mode and flow control (the
flow control default is disabled) abilities to its partner.
Current Auto Negotiation
setting.
Admin Speed The configured speed at which the LAG is
operating.
Current LAG Speed
(Read-only) The current speed at
which the LAG is operating.
Admin Flow Control Enables or disables flow control or
enables the auto negotiation of flow control on the LAG.
Current Flow Control (Read-only) The current flow
control setting.
PVE
Displays the PVE group to which the LAG is
configured.
If the LAG has been
Enables or disables Auto
The current Auto Negotiation
25