Cisco Linksys SGE2010P Admin Manual page 41

Using the Console
System Configuration
TraceRoute IPv4
You can use the TraceRoute IPv4 screen to run a trace route test for an IPv4 address
To open the screen:
1. From the Switch Main Menu, select 1. System Configuration.
2. From the System Configuration Menu, select 6. IP Configuration.
3. From the IP Configuration menu, select 5. Network Configuration.
4. From the Network Configuration menu, select 3. Trace Router IPv4.
To change the IP address:
1. Select Edit, and then enter the IPv4 address.
2. Press the Esc key to move the cursor to the Action list.
To begin the trace route test:
1. Select Execute to begin the test.
2. After the test is complete, the results of the test appear on the screen.
3. When the Operation complete message appears, press the Esc key to move the cursor to the
Action list.
SGE2010/SGE2010P Administration Guide 38