Table of Contents
Advertisement
5.1.2. Mounting PSV Up plows on a truck/tractor
In order to mount PSV Up plow on truck/tractor the following should be performed (Fig. 7):
install control panel,
plug in power plug to lighter's connector,
connect hydraulic hoses to vehicle,
it is recommended to retract both cylinders responsible for shields' shifting (item. V) in order to
provide the plow's better stability,
lift the hitch up to required mounting height,
set the vehicle in position which enables plow to be mounted on, so that hitch holders are above
linkage connectors,
lower plow's hitch onto vehicle's/tractor's front linkage (with use of the hydraulics),
upon mounting of the hitch on DIN linkage, protect the connection with M27 bolts.
Place hitch holders in
front linkage connectors
PSV Up Snow Plow features unloading assembly. In order to use it perform the following:
upon mounting the machine lift the plow by means of vehicle's hydraulics and close the valve on
connector hose located nearby EURO plug,
lower the plow to 5÷10 cm above the ground so it does not touch the surface,
read out pressure value from the gauge,
next while lowering the plow by means of the vehicle's hydraulics set pressure value for 5÷10
bar less than indicated on the gauge.
5.1.3. Mounting PSV Up H plow on a truck
PSV Up H Snow Plow can be mounted directly on vehicle's front linkage. In order to mount
the plow on the vehicle perform the following:
take hydraulic power supply cover off,
connect main power supply 3-pin plug,
turn switch MOUNT on and while holding UP button lift the hitch up to required mounting
height (switch underneath power supply cover Fig. 9),
set the vehicle in position which enables plow to be mounted on, so that hitch holders are above
linkage connectors (Fig. 8),
lower plow's hitch onto vehicle's DIN linkage while holding DOWN button (switch underneath
power supply cover Fig. 9),
Operating manual
Fig. 7. The PSV Up plow mounted on the truck
- 11-
Tractor mounted snow plow
PSV, PSV Up, PSV Up H
Protect hitch with bolts
by screwing to front
linkage
Advertisement
Table of Contents
