Tripp Lite B110-SP-CAT-OD2 Quick Start Manual page 5

Ip68-rated gigabit poe outdoor in-line surge protector

Hide thumbs Also See for B110-SP-CAT-OD2:

Table of Contents

Available languages

Protecting Edge-Of-Network Equipment

This installation protects your edge equipment from surge,

lightning or ESD damage. To protect both the source and edge

equipment, refer to section Protecting Edge-Of-Network

Source and Equipment in this guide.

Note: Use standard size Cat5e, Cat6 or Cat6a cables that feature a

wire gauge of 23/24 AWG. Slim category cables are not supported.

1. Remove both the cap

2. Slide the cap and remaining portion of the cable gland onto

Note: Use standard Cat5e, Cat6 or Cat6a cables with a wire gauge

of 23/24 AWG. Slim category cables are not supported.

21-02-277-933D64-Book.indb 5

Installation

cable glands (refer to section Cable Gland Assembly).

both the included grounding wire and bare-wire category

cable coming from your source (ex: PoE switch) as shown:

and end nut

from one of the

7/27/2021 11:40:29 AM

Table of Contents