Table of Contents
Advertisement
Quick Links
Owner's Manual
TouchMaster PLUS
Command Console PLUS
Command Console
Your Tripp Lite Under-Monitor Surge Suppressor protects your sensitive electronic equip-
ment from spikes, surges and line noise on the AC power line. It features convenient, fin-
gertip control of AC power for your computer and various peripherals, as well as advanced
diagnostic indicators that display power-protection status. PLUS models include a set of RJ-
style phone jacks for protection against spikes, surges and line noise on a single telephone
line. TouchMaster and Command Console models (except Command Console Compact)
include premium ISOBAR
POSITIONING YOUR UNDER-MONITOR
SURGE SUPPRESSOR
The Under-Monitor Surge Suppressor is designed to be placed between your computer and
monitor. Place the unit on top of your computer and then place your monitor on top of
the Under-Monitor Surge Suppressor's housing. Each Under Monitor Surge Suppressor is
sturdy enough to support the weight of a computer monitor.
Copyright © 2002 Tripp Lite. PowerVerter
TouchMaster
Command Console
Power Center (PC 5)
Under-Monitor Surge Suppressors
Canadian National
Standards
Certified by UL
®
surge suppression.
1111 W. 35th Street Chicago, IL 60609 USA
Customer Support: (773) 869-1234 • www.tripplite.com
™
(MT-6)
™
(MT 6PLUS)
®
(CCI 6)
®
Compact (CCC4)
®
®
is a registered trademark of Tripp Lite. All rights reserved.
(CCI6PLUS)
Advertisement
Table of Contents
Related Manuals for Tripp Lite TouchMaster (MT-6
Summary of Contents for Tripp Lite TouchMaster (MT-6
- Page 1 Standards Certified by UL Your Tripp Lite Under-Monitor Surge Suppressor protects your sensitive electronic equip- ment from spikes, surges and line noise on the AC power line. It features convenient, fin- gertip control of AC power for your computer and various peripherals, as well as advanced diagnostic indicators that display power-protection status.
- Page 2 Introduction CONNECTING YOUR UNDER-MONITOR SURGE SUPPRESSOR Connection to AC Power Line (all models) The Under-Monitor Surge Suppressor power cord should only be connected to a standard 3-wire grounded 120-Volt AC, 60-Hz outlet. CAUTION! DO NOT connect to an ungrounded AC outlet. DO NOT connect to 2-wire extension cords or adapters.
-
Page 3: Connecting Your Equipment
Introduction continued CAUTION! DO NOT drill into any part of the housing. DO NOT open, as there are no user-serviceable parts inside. Connecting Your Equipment (See Front and Rear Panel illustrations on page 5 for connection to your specific model.) After you have properly connected your Under-Monitor Surge Suppressor to the AC line and telephone line (if applicable), you can connect the AC power cords of your equip- ment to the surge suppressor. -
Page 4: Circuit Breaker
Features Circuit Breaker (all models) If the current draw of the equipment connected to the surge suppressor exceeds 15 amps for longer than a few seconds, the circuit breaker will open (trip) to prevent any possible damage. When the circuit breaker trips, the plunger will be extended. Remove the overload and allow the breaker to cool for one minute before depressing the plunger to reset. -
Page 5: Front Panels
Front Panels FRONT PANEL FEATURES Switches 1) Individual 2) Master Indicator Lights 3) Protection Present 4) Line Fault TouchMaster 5) Line “OK” 6) Low Voltage TouchMaster PLUS Command Console Command Console PLUS Command Console Compact Command Console Compact... -
Page 6: Battery Selection
"Specifications" section. Should you require service, call Tripp Lite Customer Support at (773) 869-1234. Explain fully the perceived problem to the cus- tomer support person. -
Page 7: Specifications
Specifications No. of AC Line Cord* No. of Control AC Energy Surge Transient Ultimate AC Receptacles Length Switches Absorption Suppression Response Dimensions Lifetime Model (NEMA 5-15R) (ft.) Master/Aux. (joules) (amp spikes)** Time (H x W x D, in.) Insurance TOUCHMASTER 1280 96,000 0 ns. -
Page 8: Warranty
Service under this Warranty can only be obtained by your delivering or shipping the product (with all shipping or delivery charges prepaid) to: Tripp Lite, 1111 W. 35th Street, Chicago IL 60609. Seller will pay return shipping charges.