Advertisement
Regularly check all mounting screws and make sure they are properly tightened. If any of the
screws come loose, tighten them immediately. Failure to do so can result in injury.
Do not expose the device to rain or water. Do not use power tools in damp or wet rooms. Al-
ways keep the work area well lit. Do not use power tools in areas where there is a risk of fire
or explosion.
Security advice
The cable must not be loose. This must be checked regularly before the tool is started up.
Never operate the device with a damaged cable.
During commissioning, the vibrator must match the local FI circuit breaker. The functionality of
the residual current circuit breaker must be checked regularly.
The operator should wear rubber shoes while working with the tool.
If the motor or the tool has problems, please contact the manufacturer or a qualified specialist.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61327, 61562, 61563, 61565, 61567
Page 5
02
2021-1
Advertisement
