Related Manuals for Pacifica GT400
Summary of Contents for Pacifica GT400
- Page 2 Check out our wide clay selection on lagunaclay.com Rod's Mix 83 Brown Dark Brown . . . � '· . . ·.� -� ·• . ,, · .. ,: · < • . · · · ..: .
- Page 3 • Inspect the box on all four sides for signs of damage from shipper. • Open the box and remove cardboard supports in order to visually see the Pacifica Wheel and inspect it carefully for any damage. • Do not sign or accept delivery without visually inspecting the package for any damage.
- Page 4 Laguna Clay Co. Pacifica Potter’s Wheel Owner’s Manual Serial #: ______________________________________________________________________________ Date of Purchase: ______________________________________________________________________ Company Purchased From: _______________________________________________________________ *** Keep for your records ***...
- Page 5 Safety Warnings: It takes 2 people to pick up and/or move a Pacifica Wheel. To avoid injury, DO NOT ATTEMPT to lift the wheel on your own. Discontinue use of the Pacifica Wheel immediately if you experience any of the following: •...
- Page 6 Forcing a wheel to stop while in motion can cause injury to person and damage the shaft and/ or the motor. • Children should always be supervised by an adult when using the Pacifica wheel. Keep tools and small parts out of reach. •...
- Page 7 SEVEN EASY STEPS TO REPAIRS 1. Review trouble shooting section of the manual. 2. Contact your Pacifica distributor with the equipment serial number, the date and location of purchase, and a detailed description of the problem. Without this information warranty work cannot be considered.
- Page 8 Depress the foot pedal up and down several times to familiarize yourself with the variable speed and stopping. • You are now ready to throw on your new Pacifica Potter’s Wheel. Troubleshooting Guide: Wheel will not turn on. No power to the wheel: •...
- Page 9 Tensioning the V belt: Your Pacifica Wheel was shipped with proper tension however, over time, with use, it may lose some of that tension and will need to be adjusted. To adjust the tension on the belt, follow the guide below or visit Laguna Clay Company’s You Tube Chanel for step by step video instructions.
- Page 10 Adjusting tension on the foot pedal: You will need a 9/64 size hex head Allen wrench • Turn Off and unplug your wheel before beginning. ( Figure 1) • Turn pedal upside down, locate the 2 pedal adjustment screws as shown. (Figure 2) •...
- Page 11 Using a 7/16 size wrench, remove the bolt at the top of the control box and remove the whole box. DO NOT OPEN THE CONTROL BOX. The control box with the foot pedal can now be sent in for inspection and/or repair independent from the Pacifica wheel itself.