Zanussi ZDLN1510 User Manual page 37

Problem and alarm code
The appliance does not drain the water.
• The indicator
termittently.
• Acoustic signal sounds 2 times inter-
mittently.
The anti-flood device is on.
• The indicator
termittently.
• Acoustic signal sounds 3 times inter-
mittently.
Malfunction of the water level detection
sensor.
• The indicator
termittently.
• Acoustic signal sounds 4 times inter-
mittently.
Malfunction of the wash pump or the drain
pump.
• The indicator
termittently.
• Acoustic signal sounds 5times inter-
mittently.
The temperature of the water inside the
appliance is too high or malfunction of the
temperature sensor occurred.
• The indicator
termittently.
• Acoustic signal sounds 6 times inter-
mittently.
Technical malfunction of the appliance.
• The indicator
termittently.
• Acoustic signal sounds 12 times inter-
mittently.
The level of water inside the appliance is
too high.
• The indicator
termittently.
• Acoustic signal sounds 15times inter-
mittently.
The appliance stops and starts more
times during operation.
The programme lasts too long.
flashes 2 times in-
flashes 3 times in-
flashes 4 times in-
flashes 5 times in-
flashes 6 times in-
flashes 12 times in-
flashes 15 times in-
Possible cause and solution
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clog-
ged.
• Make sure that the drain hose has no kinks or
bends.
• Close the water tap.
• Make sure that the appliance is correctly installed.
• Make sure the baskets are loaded as instructed in
the user manual.
• Make sure that the filters are clean.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the temperature of the inlet water
does not exceed 60°C.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the
right height above the floor. Refer to the installation
instructions.
• It is normal. It provides optimal cleaning results and
energy savings.
• If the delayed start option is set, cancel the delay
setting or wait for the end of the countdown.
37