Sharp VC-MH80 Service Manual page 11

Jig Item
12 Special Bladed Screwdriver
14 Torque Driver
15
Reverse Guide Height
17
Adjusting Jig
P a t - t N o . code
JiGDRiVERH-4 AP
CB
U
11
Configuration
Thisscrewdriver is used for adjusting
the guide roller height.
This is used to screw down resin-
made parts: the specified torque is 5
This Jig is used for height adjust-
m e n t o f t h e AK h e a d a n d
position.
This Jig is used for replacement of
the SI roller.
This Jig is used for height adjust-
ment of the reverse guide.
VC-MH80
Remarks