Advertisement
Drawing for the Installation of Indoor and outdoor Unit
The models adopt HFC free refrigerant R32
No barrier in the front
The marks from
to
A
in the gure are the
G
parts numbers.
more than 200cm
Indoor Unit
1.Installation of the indoor machine
Making a Hole on the Wall and Fitting the Piping Hole Cover
- Positon of the wall hole
Wall hole should be decided according to installation place and piping direction
(refer to installation drawing on the left).
- Making a wall hole
Make a wall hole with a little slope towards outside. Install the guard ring and seal it
with plaster.
- Fixed the indoor machine
The top of the machine is fastened to the wall with a metal bracket.
The whole machine is placed horizontally, and the inclination is less than 1°.
Installation of metal bracket
There is no gap between the metal bracket and the machine and
is fastened with screws (Fig. 1). After the machine is placed horizontally,
the metal bracket is connected to the wall by screws(Fig. 2).
More than 10cm
Back
More than 10cm
Left
More than 10cm
Guard
ring
Front
Left
more than 60cm
more than 30cm
Front
22
Arrangement of piping directions
Right
G
F
A
C
Back
D
E
Right
more than 60cm
Indoor side
Wall hole
Fig. 1
LEFT
BACK
RIGHT
Optional parts for piping
Non-adhesive tape
A
Adhesive tape
B
Saddle (L.S) with screws
C
Connecting electric cable
D
for indoor and outdoor
E
Drain hose
F
Heating insulating material
Piping hole cover
G
Outdoor side
Thickness
of wall
(Section of wall hole)
Fig. 2
Advertisement
