Operating Instructions; Setup; Operation - Chauvet TFX-DC4 User Manual

O
PERATING

Setup

Although lighting fixtures with or without motors can be connected to the Stage 4 it is important to
avoid dimming fixtures with motors. Only use the faders to dim parcans, pinspots or fixtures without
internal motors.
MAX.LOAD
11 0V 550W
230V 11 50W
No more than a "combined" 1700 watts in 120V AC
and 3400 watts in 230V AC should be connected to
the Stage 4. Exceeding this amount may cause the
device to abruptly trip its 15 Amp circuit breaker.

Operation

1) The Stage 4 is a plug and play controller pack. Simply connect your lighting fixtures to the
outlets in the rear and turn the power switch on.
2) Choose a chase program by turning the (5) position rotary knob.
3) Adjust the Sound Sensitivity knob to enhance the playback of the chase while in a sound
activated chase program. Likewise, adjust the Speed knob while in any other chase program.
4) If chasing conventional lighting, use the channel faders freely to adjust intensity of the lights.
5) Press the FULL ON button to cease the chase and turn all lights permanently on. Channel
faders continue to function and in this setting the Stage 4 can be used as a regular dimmer pack.
6) Press the BLACK OUT button to stop all output from the Stage 4. All lights will turn temporarily
off until the button is pressed again.
TFX-DC4 User Manual
I
NSTRUCTIONS
MAX.LOAD MAX.LOAD
11 0V 550W 11 0V 550W
230V 11 50W 230V 11 50W
CH. 4 CH. 3
5A 5A
6
MAX.LOAD
11 0V 550W
230V 11 50W
CH. 2 CH. 1
15
5A 5A
Amp
Max
POWER INPUT
110V
230V
2006-01-27 5:37:23 PM