Removing The Air Filter; Cooling Fluid Level - PIAGGIO MP3 300 hpe 2020 Manual

Removing the air filter (03_13)

To remove and clean the air filter as instructed in the scheduled maintenance table,
contact an Authorised Service Centre.
03_13

Cooling fluid level (03_14, 03_15, 03_16, 03_17)

The cooling of the engine operates by forced circulation of liquid. The cooling circuit
contains a coolant, made up of a mixture of 50% purified water and 50% glycoethylene
antifreeze with corrosion inhibitors. The liquid that is found in the container is already
mixed and ready to use.
For the proper functioning of the engine it is necessary for the coolant temperature to
be maintained at about 90°C (indicator at mid-scale of instrument, approximately). If
the instrument indicator enters the red zone stop the engine, allow it to cool down and
check the level of the liquid; If it is as it should be contact an Authorised Service
Centre.
03_14
check the fluid when the engine is cold, according to the scheduled maintenance table,
in the way shown below:
1. Place the vehicle on the stand, and remove the screw from the expansion tank
cover, as indicated in the photo.
2. Remove the expansion tank cap «A» rotating it anticlockwise.
3. Look inside the expansion tank: the level of the fluid must always be between the
MIN. and MAX. levels.
4. If necessary, perform the top up, with the engine cold, in the case that you find the
liquid is too close to the minimum level.
03_15
78