Advertisement
Available languages
Available languages
Magnetic sensor installation
1.
The distance between both sensor units must be less than 10mm.
If the LED light on the magnetic sensor lights up when the door is open, it means that it was installed
2.
correctly.
3.
If the sensor LED flashes when activated, it means the battery is low and will need to be replaced.
4.
The transmission distance of the sensors is less than 100 meters in an open area, test the distance before
installing it.
5.
Obstacles can change the transmission distance.
Motion sensor installation
To eliminate false alarms, please pay attention to the following installation points:
1.
Do not install in front of a window.
2.
Do not place it in front of large objects that might move easily or obstruct the transmission signal.
3.
Do not place it near a source of cold or hot air.
4.
Do not install two or more detectors in the same area, this will cause interference between them.
When the detector is activated and the LED light flashes, it means the battery is low, please replace it
5.
as soon as possible.
6.
The detection distance is 8 meters, the transmission distance is less than 100 meters. Please test the
distance before installing it.
7.
Obstacles may interfere with it.
30
2m
4m
6m
8m
Advertisement
