Advertisement
Available languages
Available languages
2.
Sensors:
a.
Press the main unit's reset button (CDDE) twice, the SOS light will turn on and the voice assistant will
say "adding 1 zone".
b.
Activate the sensor until you hear the message "added successfully".
c.
Press the reset button (CDDE) once more to continue adding sensors.
d.
The alarm supports up to 24 sensors.
e.
To remove sensors, press the Reset button (CDDE) twice to enter zone 1, 3 times to enter zone 2, and
so on. Once inside the zone of the sensors you wish to delete, press and hold the reset button (CDDE)
for 3 seconds until you hear the "beep" twice.
GSM Operation
1.
Emergency call
When the alarm is triggered by the SOS option or when a sensor is activated in the arming mode, the main
unit will call the registered phone numbers one by one in sequence. When answering the call, you will be
able to control the alarm by pressing the following keys:
a.
Press [1]: To arm the system, (the main alarm panel will continue to call the phone numbers in sequence).
b.
Press [2]: To stop the alarm and disarm the system. The main alarm will not make any alert call.
c.
Press [3]: To access the main unit's audio.
d.
Press [5]: To use the two-way audio between the phone and the main unit.
e.
Press [7]: To turn on the external siren (not included).
f.
Press [8]: To turn off the external siren (not included).
g.
Press [*]: To hang up, the alarm will continue calling the phone numbers in sequence.
2.
Operation via phone call
You will be able to operate the functions of arming, disarming, intercom, among others, through a call
as described below:
1.
Call the number of the SIM card installed in the main unit.
2.
When entering the call, dial the password (the default password is 1234, you can change the password
later).
3.
Enter one of the following digits on your cell phone's keypad:
a.
Press [1] to arm the system.
b.
Press [2] to disarm the system.
c.
Press [3] to access the audio in the main unit.
d.
Press [5] to use the two-way audio between the phone and the main unit.
e.
Press [7] to turn on the external siren (not included).
f.
Press [8] to turn off the external siren (not included).
g.
Press [*] to exit.
h.
Press [#] to set the alarm through numeric commands.
The main unit can be set via message or phone call using the password and the different commands (see
the command table from page 29).
Note:
If you do not perform any operation within 20 seconds, the phone call with
the main unit will end automatically.
Note:
Voice messages are in Spanish language.
29
Advertisement
