Table of Contents
Advertisement
Step
Category step
Distribution modes (time/load)
Power distribution calculation
target*
Energy saving distribution setting
Setting the monthly cut-off days
Distribution
Setting the regular hour range
6
related
Setting specified days
Currency for electricity charges*
Setting the capacity of the indoor
units*
7
Setting the capacity of the electric
heater*
Schedule for a single day
Scheduling
7
Allocating a schedule to a calendar
related
Schedule group
Input point (names and
conditions)*
8
Event control
Output point (names and
operation)*
IP address, net mask, DHCP, etc.
9
Network related*
Setting to send alarm mails
11
User ID, password, privileges
Buzzer volume
Brightness of the back light
Intelligent
Auto logout time
10
controller related
Identification number
Initialise the days accumulated
data*
12
*1
Attention needs to be paid to administration divisions when devices such as systems controllers are to be used in conjunction with this unit.
*2
Settings required when area administration is to be performed.
*3
Select the object of calculations for electricity distributing from the following:
Operating hours
Select when consideration is to be paid to the electricity for the indoor units. The electricity for outdoor units and indoor units are both
loaded into this unit and distributed.
Thermostat on times Select when no consideration is to be paid to the electricity for the indoor units. The electricity for outdoor units only is loaded into this
unit and distributed.
*4
If the air conditioning units included in the system are multi-function types supporting simultaneous heating and cooling or ice thermal storage models, settings
are required.
*5
Settings are required when only the accumulation operating time is to be managed.
*6
This must be set if you want to display charges.
*7
This only needs to be set for interface adaptors.
*8
This is used when calculating load distributing.
*9
Set items such as batch startup and stopping from external input.
*10 Set items such as batch alarm output to external devices.
*11 Required when logging in through a network device to operate and monitor.
*12 Clears the data calculated from test operation of the air conditioning units before hand over.
Setting
Distribution mode settgs
Distribution mode settgs
3
Distribution mode settgs
Calndr stgs fr DistrCalc
Calndr stgs fr DistrCalc
Calndr stgs fr DistrCalc
Distribution Ratio sttgs
6
I/D unit settings
I/D unit settings
8
Schedule setting
Calendar
I/D unit settings
Event control
9
Event control
10
Network settings
Email settings
Web user settings
Display/Volume settings
Display/Volume settings
Display/Volume settings
Initialize
Initialize
Air
Screen menu names
conditioning
operations
only
Operation
Distribution rate
Quantity used,
display only
charges display
Time
Load
Time
4
*
*
5
Load
4
*
13
Advertisement
Table of Contents
