On-Site Positioning; Robox Dv Sizes 2-3-4; Robox Dv Sizes 5 - Robuschi Robox Evolution RB-DV Operating And Maintenance Instructions Manual

4.3 On-site positioning

4.3.1 ROBOX DV sizes 2-3-4

For the sizes ROBOX DV 2-3-4 remove the front panel or the front panels
of the noise hood using the key
Lift ROBOX DV using a fork lift and respect strictly the lenght L indicated
in the table below
ROBOX DV 2
L 900
Position ROBOX DV as indicated at paragraphe 4.2
It is possible to fix ROBOX DV on the floor
Remove also the rear panel
Drill the floor as indicated in Fig. 8.2
Fix the feet by expansion bolts
Expansion
ROBOX DV
anchor bolt
2 12 x 112
3 12 x 112
4 12 x 112
4.3.2 ROBOX DV size 5
Position ROBOX DV as indicated in paragraph 4.2 and fix
ROBOX DV on the floor by means of anchor bolts as
indicated in figure 8.3.
Install the noise hood following the specific instructions of
the noise enclosure
Expansion
Q.ty
anchor bolt
5 12 x 12 16
3 4
1200 1200
Floor drilling
D L
mm mm
12 105
12 105
12 105
Floor drilling
D L
mm mm
12 105
Fig.8.1
D
Fig. 8.2
D
Fig. 8.3
30 / 44