Table of Contents
Advertisement
OPERATION
使用方法
Quickly remove PM2.5.
快速去除PM2.5。
Press this button to quickly remove PM2.5 and automatically control the air
volume (air volume indicator is off), until the indoor PM2.5 concentration is
lower than the PM2.5 concentration baseline (factory setting is 35 µ /m
(button lights
觸摸此鍵產品快速去除PM2.5並自動控制風量大小(風量指示燈熄滅)，直到室內PM2.5
up)
濃度低於PM2.5濃度基準(出廠時的設置為35 µ /m
(觸摸鍵亮起)
(At this moment, the PM2.5 mode automatically stops and switches to the
previous mode operation.)
(此時PM2.5運轉自動停止並跳轉到之前的模式運轉。)
When the indoor PM2.5 concentration is lower than the PM2.5 concentration
baseline, after press this button, PM2.5 mode will automatically stop after
approximately 1 minute and then switch to the previous mode operation.
當室內PM2.5濃度低於PM2.5濃度基準時，觸摸此鍵，PM2.5模式將運轉約1分鐘後自動
停止並跳轉到之前的模式運轉。
Method to set up the PM2.5 concentration baseline:
When the product is stopped operating, press
moment all the control buttons, filter replacement indicators, air volume
indicators blink. Under such condition, each press the
in the order shown below on the PM2.5 concentration/ timer display window.
About 15 seconds after the selection is completed, the setting will be
automatically saved, and the setting is completed.
設置PM2.5濃度基準方法：
產品停止運轉的狀態下，觸摸
風量指示燈閃爍。在此狀態下觸摸
順序進行切換。選擇完成後約15秒，將自動保存設置，設置完成。
Notice 提示事項
Timer setting is disable when operating in PM2.5 mode.
當以PM2.5模式運轉時，不能進行定時設置。
Press this button again to disable this mode.
再次觸摸此鍵取消此模式。
Set PM2.5 concentration baseline to 35 µ /m
設置PM2.5濃度基準為35 µ /m
Set PM2.5 concentration baseline to 75 µ /m
設置PM2.5濃度基準為75 µ /m
(PM2.5 concentration/
timer display window)
(PM2.5濃度/定時顯示窗顯示)
PM2.5
3
)。
for about 3 seconds, at this
鍵約3秒，此時所有觸摸鍵、過濾網更換指示燈亮起，
鍵，每觸摸一下，PM2.5濃度/定時顯示窗將按下圖
).
3
will switch the baseline
3
3
3
3
使
用
方
法
9
Advertisement
Table of Contents
