Advertisement
MAINTENANCE & CLEANING
IMPORTANT: Always switch off and unplug the machine before performing maintenance or troubleshooting checks.
Switch the machine off before connecting or disconnecting the lift-out, hose and accessories or before emptying the dirt container.
The motor is equipped with a thermal cut-out. If for any reason the machine should overheat, the thermostat will automatically
turn the machine off. If this happens switch off and unplug the machine. Remove and empty the dirt container.
Check the machine for blockages and clean the filters if required. Allow the machine to cool for approximately 1 hour.
If you have washed the pre-motor filter, wait 24 hours or until fully dry before putting it back into the machine.
Emptying the dirt container
IMPORTANT: Don't over fill the dirt container to avoid blocking the air flow through the machine.
DIRT
CONTAINER
Press the dirt container release buttons located on the
side of the carry handle, pull to remove the dirt container.
Cleaning the pre-motor filter
IMPORTANT: Wash the pre-motor filter with warm water (40°C max) and leave for 24 hours or until fully dry before
replacing into the machine. For best cleaning results, filters should be tapped over a bin every 4-6 uses to remove dirt/
debris, washed every 3 months (depending on the level of use) and replaced every 9-12 months. Ensure all filters are in
place before using the machine.
Push the dirt container lid
release clip upwards to
open the container lid.
12
Pull the pre-motor filter
tab and remove the filter.
Hold the dirt container over
a bin. Press the dirt release
button to open and allow
the dirt to fall out.
Tap the filter over a bin
to remove any dirt/debris.
To close, push the dirt
release door until it clicks
into place.
40°C
MAX
24hr
Wash the filter under
running water (40˚ max).
Leave for 24 hours or until
fully dry before replacing.
support.vax.co.uk
Hide quick links:
Advertisement
