NEC LAVIE PM9560 User Manual page 8

4 Power lamp Lamp that lights up when the power is turned ON.
( )
Power Lamp
Status
Lights in blue
Blue flashing
Lit orange
Blinking
orange
Off
* If you continue to use the computer with only battery power
while the battery level is low, the computer automatically go into
sleep mode.
Notes on using USB compatible devices
• When connecting or disconnecting a USB compatible device, wait at
least 3 seconds.
• If the USB device is not recognized properly, unplug it from the USB
connector and plug it in again.
• Do not plug in or unplug the USB compatible device during the power
saving state, during transition to the power saving state, or during
recovery. Also, do not operate the connected USB compatible device
during the transition to the power saving mode.
• The maximum power supply capacity per USB connector is as follows.
- When the computer is turned on:
USB3.1 Type-C connector, USB3.0 Type-C connector: 1.5A USB3.1
connector: 0.9A
- When in sleep mode:
A few tens of mA about
8
When the AC adapter When the AC adapter
is connected is disconnected
The power is ON
Sleep state
The power is ON and
–
the battery is low
one of the following
• The power is ON and
–
the battery is low
• In sleep mode,
battery level is low
Power is off or the computer is in sleep mode*
Left side, back
1 Headphone / A terminal for connecting headphones or a headphone
headphone microphone(4-pole mini plug) for smartphones. A terminal for
microphone connecting external speakers and audio equipment to output and
input audio signals.
terminal ( )
2 microSD Slot for installing "microSD memory card", "microSDHC memory
memory card card", "microSDXC memory card". Insert the memory card with
the front side facing up.
slot ( )
3 Battery Lamp that lights up when the battery is charging.
charging lamp
Battery charge
lamp status
Solid orange
Flashing orange
Off
*1: Results in an error when the battery is charging, or error when
the battery life is dead or deteriorates.
*2: If the battery is already fully charged or almost fully charged,
the lamp may not light up and further charging may not be
possible.
When the battery charging lamp is charging, the battery level may
be displayed as 100% in Windows, but this is due to an error
when displaying the battery level in Windows and is not a
malfunction. Also, check the charging lamp for completion of
battery charging.
1
2
3
Battery charge status
Battery charging
*1
Battery error
The AC adapter is not connected or
*2
charging is complete