Initial Setup; File Menu And Toolbar; Open And Close Communication - Sierra Wireless AirPrime User Manual

Rev 5.0 Apr.20

Initial Setup

After the Development Kit and PC are connected, the first step is to set up the
COM port and baud rate.
1. Click the combo box at the bottom of the screen to select either COM Port or
USB Port.
2. Select the port number of the Development Kit.
3. Select the baud rate of the Development Kit. (You don't need to select the
baud rate if you've previously selected USB port in step 1.)

File Menu and Toolbar

Open and Close Communication

Click the cable button on the toolbar to open communication.
Figure 2-2: Cable Button
To disconnect signal reception, click the cable button again.
If using a USB connection with the XA12xx or XM12xx, ensure that the firmware
version indicated in the lower left corner of the window is correct. If the firmware
version is not detected, reconnect the Development Kit and PC.
Figure 2-3: Series Model and Firmware Version on the Status Bar
Note: Click the port combo box again to refresh the port list.
7
Operation
41111068