Advertisement
7. Using the pre-drilled holes as guides, insert two 8x90mm Machine Thread Eye Bolts. To help you
gain better leverage to twist the bolt, insert the shank of a screwdriver into the eye. USE CARE
TO NOT OVER-TIGHTEN THE BOLTS. See Figure 7.
N
Fig. 8a
8. Using the pre-drilled holes as guides and the hex wrench of your choice (R or U), attach a Shelf
(E) to the left side with two 8x60mm Hex Bolts (N). See Figures 8 and 8a. Repeat for the right side.
9. If needed, adjust the Levelers (Q) in the bottoms of the legs.
10. Follow the 4301KFBA Eden Swing assembly instructions for steps to hang the swing from the
4302KFBA Eden A-Frame.
Page 6 – 4302KFBA – 01/10
M
Fig. 7
E
N
M
E
Fig. 8
M
N
N
N
x 2
x 4
x 2
Advertisement
