Advertisement
I
A
H
G
2. Repeat step one to attach the Left Side Assembly (A) to the Back (C) and Bottom Supports (E).
See Figure 2.
Fig. 3
NOTE: To make this assembly easier, use a variable speed drill with a Phillips Driver Bit instead of
a Phillips Screwdriver to tighten the screws.
3. Using the predrilled holes as guides, attach the Seat (D) to the supports and side assemblies with
six 4x50mm Screws (K). See Figure 3.
Page 4 – 4301KFBA – 12/09
J
J
I
J
K
K
G
x 1
H
x 2
I
x 2
J
x 3
Fig. 2
x 6
Advertisement
