Hilti HIT-CT 1 Instructions For Use Manual page 20

Hilti HIT-CT 1
Adhesive anchoring system for rebar and anchor fastenings in concrete
Prior to use of product, follow the instructions for use and the safety precautions.
▶
Hilti HIT-CT 1
Contains: Dibenzoylperoxid (B)
(B)
H411
P262
P302+P352
P305+P351+P338
EUH208
Disposal considerations
Empty packs:
▶ Leave the mixer attached and dispose of via the local Green Dot recovery system
▶ or EAK waste material code: 150102 plastic packaging
Full or partially emptied packs:
▶ Must be disposed of as special waste in accordance with official regulations.
– EAK waste material code: 08 04 09* waste adhesives and sealants containing organic solvents
or other dangerous substances.
– or EAK waste material code: 20 01 27* paint, inks, adhesives and resins containing dangerous
substances.
Content: 330 ml / 11.1 fl. oz 500 ml / 16.9 fl. oz
Hilti accepts no liability for damage or failure caused by:
– Storage and transport not in accordance with the specified conditions
– Failure to observe the instructions for use and setting data
– Inadequate design of the anchor points
– Inadequate load bearing capacity of the base material
– Incorrect use
– Other influences of which Hilti is not aware or on which Hilti has no influence, e.g. use with
products from a third party
20
Toxic to aquatic life with long lasting effects.
Do not get in eyes, on skin or on clothing
IF ON SKIN: Wash with plenty of water.
IF IN EYES: Rinse cautiously with water for several minutes.
Remove contact lenses, if present and easy to do. Continue rinsing.
Contains dibenzoyl peroxide. May produce an allergic reaction.
Weight:
600 g/21.1 oz 910 g/32.1 oz