Toshiba SHRM R410A Quick Reference page 65

(5) Display of Indoor Unit Information (Displayed on Header Unit Only)
SW01 SW02 SW03
Indoor BUS communication signal
4
receiving status
5 Indoor check code
6 Indoor HP capacity
1~3
Indoor request command
(S code, operation mode)
7
1~16
8 Indoor PMV opening data
9 Indoor TA / TRA opening data
11 Indoor TCJ opening data
12 1~3 Indoor TC1 opening data
13 Indoor TC2 opening data
Note)
Indoor address No. is selected by setting SW02 and SW03 and displayed on 7-segment display, section A.
SW02 SW03 Indoor address
1
SW02 setting number
2 SW02 setting number +16
1~16
3 SW02 setting number +32
(6) Display of Outdoor EEPROM Writing Error Code (Displayed on Header Unit Only)
* The latest error code written in the EEPROM of each outdoor unit is displayed.
(This function is used to check the error code after the resetting of the power supply.)
To display the error code, push SW04 and hold for at least 5 seconds after setting SW01 to 03 as shown in the
table below.
SW01 SW02 SW03
1 Latest error code of header unit (U1)
1 16
2 Latest error code of follower unit No. 1 (U2)
• 7-Segment Display
Set SW01/SW02/SW03 to [1/1/16] and push SW04 and hold for at least 5 seconds. The latest error code of the
header unit (U1) will be displayed.
If the setting of SW02 is changed, the latest error code of a follow unit (U2-U3) will be displayed.
B
B
B
B
B
B
B
B
B
7-segment display section A
Indoor address
Section A
D600 D601
Display detail
Upon receiving signal: [... ... 1], Other times: [... ... ...]
No check code: [– – –]
0.6 to 4.5
∗
[ #. ... ]
# represents mode:
∗ ∗
COOL: [C. ... ], HEAT: [H. ...
∗ ∗
FAN: [F. ... ], OFF: [S. ... ]
∗
represents S code: [#. ... 0] to [#. ... F]
Displayed in decimal format
Displayed in decimal format
Displayed in decimal format
Displayed in decimal format
Displayed in decimal format
[01]~[16]
[17]~[32]
[33]~[40]
Section B
D602 D603 D604
]
7-segment display section A
E. 1.
E. 2.
64
∗∗∗
∗∗∗