Chamberlain ROI2 User Manual page 2

Mounting with Tape
Step 1
Clean back of intercom and mounting surface using
the alcohol wipe.
Step 2
Peel off white paper from mounting tape. Firmly
press mounting tape on back of intercom.
Step 3
Peel paper from mounting tape. Firmly press
intercom onto mounting surface.
Assemble Intercom
Install 4 AA Alkaline batteries (not provided). (Lithium
batteries recommended for colder environments.)
Programming Intercom
The intercom must be programmed to at least one
other intercom to become a network or it can be
programmed into an existing network.
Create New Network
Press the Learn button on the new intercom until a
beep is heard. Within 5 seconds put the second
intercom into Learn Mode (refer to table below).
INTERCOM
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
Add to an Existing Network
Press the Learn button on the new intercom until a
beep is heard. Within 5 seconds put any networked
intercom into Learn Mode (refer to table below).
INTERCOM
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
NOTE: Do not program new intercoms to each other
before adding them to the network or they will form a
separate network and the memory will need to be
cleared.
2
LEARN MODE
Press the Learn button until
a beep is heard.
Press and hold both buttons
for 5 seconds.
LEARN MODE
Press the Learn button until
a beep is heard.
Press and hold both buttons
for 5 seconds.