Installation; Front Panel - EEG CB515 Manual

CB515 HD Caption Legalizer / Relocating Bridge
Section 2: Installation

Front Panel

Power LEDs
Reset
Active
USB
LCD Controls
4
The CB515 front panel is shown in the figure below.
The front panel has the following elements:
Each LED corresponds to one of the two power supplies the CB515 can be
equipped with; note that the second supply is a paid option. Green indicates
that the given power supply is active, and red indicates that it is inactive.
Performs a hardware reset. The unit will reboot, all operations will be cleared,
and status will return to the default settings stored in Startup Settings.
Controls relay bypass for the master and source video paths. In bypass, the
indicator LED will be off, and the unit will pass video directly from the Master
In connector to the Master Program Out connector, and from the Source In
connector to the Source Out connector. All other functions are inactive.
Software and firmware updates can be applied by inserting into this port a USB
flash drive containing an update file. Note that updates can also be applied via
the unit's web configuration page.
The control pad provides menu navigation for the front panel configuration
menus. The control pad buttons are: ENTER (marked by a check), CANCEL
(marked by an 'X'), LEFT, RIGHT, UP, and DOWN.
Copyright © 2009-2014, EEG Enterprises, Inc.
All Rights Reserved.
eeg