Web Configuration - EEG CB515 Manual

Utilities
Capture VANC
Capture All VANC
Capture 608

Web Configuration

Captures VANC data of the selected DID/SDID from the Master video input
and loads it onto a USB storage device. Use the UP and DOWN keys to select
the desired DID/SDID and insert a USB device into the box. Press ENTER to
begin downloading the VANC data or CANCEL to exit. To stop capturing
VANC data press any front panel key. Depending on the size and type of
memory device used, there may be a momentary delay before the device is
detected. If you see "Failed: Insert USB Disk", wait a few seconds and try
again.
Captures VANC data of all DIDs/SDIDs from the Master video input and loads
it onto a USB storage device. Insert a USB device into the box and press
ENTER to begin downloading the VANC data or CANCEL to exit. To stop
capturing VANC data press any front panel key. Depending on the size and
type of memory device used, there may be a momentary delay before the
device is detected. If you see "Failed: Insert USB Disk", wait a few seconds
and try again.
Captures CEA-608 data from the Master video input and loads it onto a USB
storage device, creating separate files for field 1 and field 2 data. Insert a USB
device into the box and press ENTER to begin downloading the VANC data
or CANCEL to exit. To stop capturing VANC data press any front panel key.
Depending on the size and type of memory device used, there may be a
momentary delay before the device is detected. If you see "Failed: Insert USB
Disk", wait a few seconds and try again.
The Web Configuration interface enables you to access configurations and log
files for your CB515 from any computer on your local network. Several web
applications are installed at the factory for all CB515 Legalizers: a Startup
Setting editor, a web-based serial-emulation Terminal for entering Smart
Encoder commands, and a documentation library.
To use Web Configuration, first connect the Ethernet connector on the rear
panel of the CB515 to your local network. Then, use the front panel LCD and
button pad to give the Legalizer a valid IP address and subnet mask for your
network by navigating to System Setup | Network Setup | IP Address and
System Setup | Network Setup | Subnet Mask.
Copyright © 2009-2014, EEG Enterprises, Inc.
All Rights Reserved.
CB515 HD Caption Legalizer / Relocating Bridge
9