EEG CB515 Manual page 10

CB515 HD Caption Legalizer / Relocating Bridge
Firmware Update
8
 Set Config is used to choose between static IP address configuration,
which allows you to set specific network settings (as described below), or
DHCP-based configuration, which will cause the CB515 to communicate
with your local DHCP server to determine network settings.
 IP Address selects the network address that the unit will request on your
LAN. Use the LEFT and RIGHT keys to move the cursor between digits
and the UP and DOWN keys to change the selected digit. When you are
finished making changes, use the ENTER key to exit the menu and save
changes or the CANCEL key to exit the menu and reject changes.
 Subnet Mask should be set to match the bit mask used on your LAN.
 Gateway should be set to the address of the computer or device that the
unit will use to communicate outside of your local network, when
applicable.
The Firmware Update utility provides a fast, simple, and convenient way to
upgrade your Legalizer to the latest version of the EEG firmware or add
additional software modules. Begin by downloading a firmware update file
from the EEG website and transferring the file to any standard USB memory
device. Insert the memory stick into the front panel USB port, navigate to the
Update option in the System Setup menu, and press ENTER. The update
utility will find the installation file on the memory device, display the revision
number, and prompt you to continue. Press ENTER to proceed and install the
new firmware, or CANCEL to end the utility. A message will appear on the
LCD screen when the update utility has finished. Do NOT remove the
memory device while the update utility is running. When the update utility
is finished, the new firmware has been installed. Some updates will require a
power-cycle before they take effect.
Updates can also be applied over your LAN on the CB515 Web Configuration
page.
Copyright © 2009-2014, EEG Enterprises, Inc.
All Rights Reserved.