Adjusting A Unit That Is Off Frequency - AOR AR1000 Manual

Hide thumbs Also See for AR1000:

Instruction manual (16 pages)

Instruction manual (7 pages)

Instruction manual (4 pages)

Table Of Contents

Table of Contents

Turn on the unit. The display will be blank. This means that the unit is ready to

be re-programmed. Carefully enter in the following keystrokes from left to right,

top to bottom. Keys are shown within brackets (e.g. [Bank]). The symbol [V]

means press the Down arrow button.

[Bank] 1 [Prog]

2 [Prog]

3 [Prog]

4 [Prog]

5 [Prog]

6 [Prog]

7 [Prog] 1110 [Limit] 1300

Turn the unit off.

Remove the wire you soldered.

Re-assemble the unit (perform the disassembly steps backwards).

Turn on the unit. It should now be working with full coverage (see caveats

below).

Following is an alternative set of parameters that is recommended with the

AR2000 unit sold in England:

[Bank] 1 [Prog]

2 [Prog]

3 [Prog]

108 [Limit]

4 [Prog]

170 [Limit]

5 [Prog]

287 [Limit]

6 [Prog]

800 [Limit] 1109.995 [V]

7 [Prog] 1110 [Limit] 1300

8 [Prog]

600 [Limit]

Caveat:

While this procedure will set up the parameters to have continuous coverage

from .5 MHz to 1300 MHz, you may not really get full coverage from 600-805

MHz in some older models. Some users report that the scanner will take frequen-

cies between 700 and 805 MHz but will not really pick anything up in this

range.

Thanks to Lionel Ancelet in France for first making this procedure available.