♦ This is similar to the method used by other scanners.
If you also use or have used a Uniden Bearcat or Radio Shack scanner, you will
find this method familiar and comfortable.
To change a
• Press MANUAL if not in Manual mode.
• Press BANK.
frequency in
• Enter the three-digit channel number.
a scan
MHz will flash in the display.
channel
• Enter the new frequency from the numeric keypad.
Use the CLEAR key if you make a mistake. Then start over by entering the frequency again.
• Press ENT.
• Press or toggle a mode key (AM, FM, WFM).
This will overwrite the current frequency in the channel. A more general way to
explain this is that you can enter a new frequency when you are at any channel
and make it permanent by toggling a mode key. This fact also means that you
can "try out" frequencies in channels with existing frequencies in them. Plug in
the new frequency and listen. As long as you don't toggle a mode key, the old
frequency will remain stored in the channel.
Locking a scan channel
You can temporarily lock a channel so that it is skipped during scanning. It's
frequency remains programmed into the channel, but the channel is not looked
at during scanning.
To lock a
• Press MANUAL if not in Manual mode.
scan channel
• Press BANK.
• Enter the three-digit channel number.
• Press LOCKOUT.
L.OUT will flash in the display, indicating that the channel is now locked.
To remove
• Press MANUAL if not in Manual mode.
the lock on
• Press BANK.
a channel
• Enter the three-digit channel number.
L.OUT will flash in the display, indicating that the channel is locked.
• Press LOCKOUT.
L.OUT disappears from the display.
Caution using Lockout
With the AR1000, the LOCKOUT key is always active. If you are scanning and
press LOCKOUT by accident, the channel that you happen to be scanning when
you press the key will be locked, even if the scanner has not stopped on that
channel. You will probably not even notice that you have locked the channel.
Scanning
18