Table of Contents
Advertisement
Installing ACP Lonworks and
connecting cables
After setting PI485, the ACP Lonworks shall
be installed in an adequate place, and RS-485
cable shall be connected for the communica-
tion with PI485.
And, Ethernet cable (LAN cable) shall be con-
nected for the connection with internet or AC
Manager.
To fix the ACP Lonworks, the following 2
methods may be used.
Install in DIN RAIL or fix to the wall consider-
ing the environment of the site.
Power
LAN cable
!
CAUTION
If four times the power con-
nector for the connection, as
shown by using the right
connection, but please note
that an electric shock.
Use the designated parts
must be connected to a
power source.
• Connector manufacturers: PHOENIX
CONTACT PartNo: MVSTBR 2,5 / 2-ST-
5, 08 2P 5.00 mm.
PLNWKB000
LON
SVC
RS-485 cable
INSTALLING ACP LONWORKS
Installing the ACP Lonworks in DIN
RAIL
ACP Lonworks can be installed in DIN RAIL
with width 35 mm and height 7.5 mm.
Proceed as the follows to install the ACP Lon-
works in an adequate place.
The installation method of the ACP Lonworks
is explained here with the example of in-
stalling the ACP Lonworks in DIN RAIL.
• Decide the space to install the ACP Lon-
works.
• Before installing the ACP Lonworks, check if
it is the adequate place to connect the ACP
Lonworks with the power, RS-485, and LAN,
LON cables.
• Install DIN RAIL.
• Hook the top part of the ACP Lonworks on
DIN RAIL.
• Push the main body of the ACP Lonworks
until you hear the sound of installation.
• Pull the ACP Lonworks to check if it is fixed.
!
CAUTION
• After installing to DIN RAIL, do not fix to
the wall using screws.
• ACP Lonworks may be damaged.
• DIN Rail fixing Screw Spec: M3, screw
head height 1.75 mm ~ 2.0 mm, screw
head diameter 5.5 mm ~ 7.0 mm.
11
Hooking on
DIN RAIL
LON
SVC
Fixing to DIN RAIL
Advertisement
Table of Contents
