Install Chain/Cable; Attach Sprocket Cover - Chamberlain 9602 Owner's Manual

Assembly Step 4
Install the Chain/Cable
& Attach the Sprocket Cover
Dispensing Carton
Install Chain & Cable
In This Direction
Install Chain & Cable
Chamberlain '92
Keep Chain and Cable
8/22/90 - 3/6/92 Taut When Dispensing
Keep Chain and Cable
Taut When Dispensing
• Detach the cable loop from the carton and fasten it
to the trolley with a master link from the hardware
bag. See master link procedure, Figure 1.
• With the trolley against the screwdriver, dispense
the cable around the pulley.
• Proceed back around the opener sprocket,
Keep Chain and Cable
Taut When Dispensing
Figure 2. Be sure sprocket teeth engage the chain.
Continue forward to the trolley threaded shaft,
Front Tab Slot
Figure 3.
• Use the second master link to connect the
chain to the flat end of the shaft. Check to
make sure the chain is not twisted.
• Remove the screwdriver.
Install Chain & Cable
In This Direction
Install Chain & Cable
In This Direction
Install Chain & Cable
Chamberlain '92
Install Chain & Cable
8/22/90 - 3/6/92
Chamberlain '92
8/22/90 - 3/6/92
Install Chain & Cable
Chamberlain '92
8/22/90 - 3/6/92
Front Tab Slot
Front Tab Slot
Cable
Pulley
Dispensing Carton
Leave Chain and Cable
Inside Dispensing
Carton to Prevent Kinking
Leave Chain and Cable
Inside Dispensing
Carton to Prevent Kinking
Dispensing Carton
Clip-On Spring
Leave Chain and Cable
Inside Dispensing
Carton to Prevent Kinking
Sprocket
Cover
Back Tab Slot
Cable
Loop
Mounting
Plate
Cable
Pulley
Install Chain & Cable
In This Direction
Sprocket
Cover
Back Tab Slot
Sprocket
Top of Opener
Cover
Back Tab Slot
Mounting
Plate
Mounting
Plate
Sprocket
Cover
Back Tab Slot
Master
Link Bar
Serious injury can result if fingers become
entangled in moving opener sprocket. Attach
sprocket cover securely. Never operate opener
while your hand is near the opener sprocket.
Figure 2
Master Link
Flat end
of Trolley
Threaded Shaft
Master
Master Link
Link Cap
Clip-On Spring
Master
Link Cap
Top of Opener
Cable
Loop
Master Link
Clip-On Spring
Master
Link Cap
Master
Link Bar
Cable
Master
Loop
Cable
Link Bar
Pulley
Cable
Pulley
To attach the sprocket cover:
Top of Opener
• Insert the back tab in the opener slot. Squeeze the
cover slightly and insert the front tab in the slot on
the mounting plate.
10
Top of Opener
Pin
Trolley
WARNING
CAUTION
Master Link
Clip-On Spring
Master Master Link
Link Cap
Clip-On Spring
Master
Link Cap
Flat end
of Trolley
Figure 3
Threaded Shaft
Master Link
Clip-On Spring
Master
Pin Notch
Link Cap
Pin
Flat end
of Trolley
Threaded Shaft
Trolley
Trolley
Trolley
Master
Link Bar
Master Link Procedure:
Push pins of master link bar through
cable loop and hole in front end of
trolley. Push cap over pins and into
notches. Slide clip-on spring over
cap and into notches until both pins
are securely locked.
Opener
Sprocket
Chain
T-rail
Chain
T-rail
Pin Notch
Pin
Chain
T-rail
Pin Notch
Pin
Opener
Sprocket
Opener
Sprocket
Figure 1
Opener
Sprocket