Install The Lights And Lenses; Attach Manual Release Rope And Handle - Chamberlain 9602 Owner's Manual

Installation Step 7
Install the Lights & the Lenses
• Install a 75 watt maximum light bulb in (each)
socket. The light(s) will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the light(s) will turn OFF.
• If a bulb burns out prematurely due to vibration,
replace with a standard-neck "Garage Door
Opener" bulb.
• Slide lenses into guides as shown. Snap bottom
tabs into lens slots.
• For convenience, the lenses may be installed
after Adjustment Step 4 on page 30.
• Reverse the procedure to remove the lenses.
Models 53315, 53415, 53515, 53625 & 53699
Installation Step 8
6/20/89 - 6/27/89
Attach the Manual Release
Rope & Handle
Trolley
Rope
Overhand
Knot
Lens Tab
75 Watt Max.
Light Bulb
Overhand
Knot
Trolley
Release Arm
Manual
Release Handle
19
WARNING
Do not use the red handle to pull the door open
or closed. The rope knot could become untied
and you could fall. Use the manual release only
to disengage the trolley and, if possible, only
when the door is closed.
Garage doors are heavy. If the door is open
when the handle is pulled, the door could close
inadvertently if it is not properly balanced.
CAUTION
Serious injury may result to persons under the
door. Make sure the doorway is clear of persons
and obstructions before pulling handle when
door is open.
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot.
The knot should be at least 1" from the end of the
rope to prevent slipping.
• Thread the other end of the rope through the hole in
the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above the
floor. Secure with an overhand knot.
If it is necessary to cut the rope, heat seal the cut
end with a match or lighter to prevent unraveling.
Lens
Guide
75 Watt Max.
Light Bulb
Lens Slot
Lens Tab
W