Table of Contents
Advertisement
Assembly Step 2
Install the Trolley on the T-rail
• As a temporary stop, insert a screwdriver into the
hole in the front end of the T-rail.
• Slide the trolley assembly along the rail to the
screwdriver stop.
If trolley hits against any nuts on the T-rail, the
bolts and nuts were attached from the wrong
side and must be repositioned. Review Step 1.
Temporary Stop
Screwdriver
Assembly Step 3
Faster the T-rail to the Opener
• Place the opener on packing material to protect
the cover. For convenience, put a support under
the belt pulley bracket.
• Remove the (2) 5/16"-18x1/2" washered screws
mounted in the top of the opener.
• Align the holes in the back section of the T-rail with
the holes in the opener.
• Fasten the rail with the (2) washered screws
previously removed. Tighten securely.
Remember to use only these screws! Any other
screws will cause serious damage to the opener.
• Insert a 5/16"-18x7/8" hex screw into the cover
protection bolt hole in the T-rail as shown. Tighten
securely with a 5/16" lock washer and nut.
NOTE: This screw prevents trolley over-travel.
Keep a 2" minimum between the trolley and this
screw when adjusting travel limits (see page 28).
Hardware Shown Actual Size
Hex Screw
5/16"-18x7/8"
Lock Washer
Nut
5/16"-18
5/16"
Hex Screw
5/16"-18x7/8"
Trolley
Stop Hole
Lock Washer
5/16"
5/16"-18
• Insert a 5/16"-18x7/8" hex screw into the trolley
stop hole in the T-rail as shown. Tighten securely
with a 5/16" lock washer and nut. This screw limits
trolley travel in the DOWN direction.
To fasten rail, use only those screws mounted
in the top of the opener. Any other screws will
cause serious damage to the opener.
Washered Screw
5/16"-18x1/2"
Hex Screw
5/16"-18x7/8"
Cover Protection
BoltHole
T-Rail
(Back Section)
Lock Washer
5/16"
Nut
5/16"-18
9
Trolley
Nut
CAUTION
CAUTION
USE ONLY THIS
TYPE AND SIZE
SCREW
Advertisement
Table of Contents
