Controller - Golden Buzzaround Carry On Service Manual

FUSE REPLACEMENT - CONTINUED
3AMP MINI GLASS - TILLER FUSE REPLACEMENT
Tools needed: None
1. Remove the key from the key switch.
3. Remove the fuse cap by turning it counterclockwise. See figure 35.
4. Remove the bad fuse.
5. Install a new fuse, insert the cap, and twist the cap clockwise to secure.
35 AMP BLADE - CONTROLLER FUSE REPLACEMENT
Tools needed: None
1. Remove the key from the key switch.
2. Loosen the two thumb screws securing the controller
cover, by turning them counterclockwise.
3. Remove the cover to access the fuse. See figure 34.
4. Remove the bad fuse.
5. Install a new fuse, into the fuse holder.
Fuse(s) must be replaced with exact type
and rating. Refer to the wiring diagram on page 11.
CONTROLLER REPLACEMENT
Tools needed: Phillips Screwdriver
1. Place the freewheel lever in the engaged position.
2. Remove the key from the key switch.
3. Remove the battery pack from the scooter.
4. Loosen the two thumb screws securing the controller
cover, by turning them counterclockwise.
5. Remove the cover to access the controller. See figure 36.
6. Unplug all connections from the controller, noting their
locations. Refer to the wiring diagram on page 11.
7. Remove the (2) screws securing the controller.
8. Remove the controller.
9. Install the new controller by reversing steps 1-8.
associated wiring.
Wire placement is critical! Misplaced wires can cause damage to the controller and
SCREW
Figure 36. Controller
20
Figure 35. Tiller Fuse (F3AL250V)
CONNECTIONS
SCREW
FUSE