Transporting And Storing Outboard Motor - Yamaha F15C Owner's Manual

F15CEH Manual tilt
F15CMH Manual tilt
F15CPH Power tilt
F20EH Manual tilt
F20ER Manual tilt
F20MH Manual tilt
F20PH Power tilt
F20PR Power tilt
Propeller mark:
J
Fuel and oil:
Recommended fuel:
Regular unleaded gasoline
Min. pump octane:
86
Fuel tank capacity:
24 L (6.34 US gal) (5.28 Imp.gal)
Recommended engine oil:
4-stroke outboard motor oil
Recommended engine oil group 1*:
SAE 10W-30/10W-40/5W-30
API SE/SF/SG/SH/SJ/SL
Recommended engine oil group 2*:
SAE 15W-40/20W-40/20W-50
API SH/SJ/SL
Lubrication:
Wet sump
Engine oil quantity (excluding oil filter):
1.6 L (1.69 US qt) (1.41 Imp.qt)
Recommended gear oil:
Hypoid gear oil SAE#90
Gear oil quantity:
3
250.0 cm (8.45 US oz) (8.82 Imp.oz)
Tightening torque for engine:
Spark plug:
18.0 Nm (13.3 ft-lb) (1.84 kgf-m)
Propeller nut:
17.0 Nm (12.5 ft-lb) (1.73 kgf-m)
Engine oil drain bolt:
28.0 Nm (20.7 ft-lb) (2.86 kgf-m)
Engine oil filter:
18.0 Nm (13.3 ft-lb) (1.84 kgf-m)
EMU28223
Transporting and storing
outboard motor
EWM00690
WARNING
Leaking fuel is a fire hazard. When
G
transporting and storing the outboard
motor, close the air vent screw and fuel
cock to prevent fuel from leaking.
USE CARE when transporting fuel tank,
G
whether in a boat or car.
DO NOT fill fuel container to maximum
G
capacity. Gasoline will expand consid-
erably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
EWM00700
WARNING
Never get under the lower unit while it is
tilted, even if a motor support bar is used.
Severe injury could occur if the outboard
motor accidentally falls.
ECM00660
CAUTION:
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
an additional support device to secure it
in the tilt position.
The outboard motor should be trailered and
stored in the normal running position. If there
is insufficient road clearance in this position,
then trailer the outboard motor in the tilt po-
sition using a motor support device such as
a transom saver bar. Consult your Yamaha
dealer for further details.
Maintenance
55