AEG MC 4412 CD/MP3 Instruction Manual & Guarantee page 50

Remote Control
1 PLAY/PAUSE button (Play/Pause)
2 STOP button
3 I NEXT/I PREV buttons
(Radio memory preset/ Track forwards/reverse)
4 FWD/ REV buttons
(FM/AM scan / Track scan forwards/reverse)
5 REPEAT button (repeat)
6 PROG button
7 RAN/BAND button (random/frequency band selection)
8 FUNCTION Function selector button
9 MUTE (sound off) button
10 VOL-/VOL+ (volume) buttons
11 FM/ST button
12 „ " button (Standby/Operation)
13 ID3 button
14 SLEEP button
15 INTRO button
16 Equalizer buttons (FLAT/ROCK/CLASSIC/POP/JAZZ)
17 „-/- -" button
18 Number buttons
19 BASS button
Start-up of the device/Introduction
• Read the operating instructions thoroughly before the start-up!
• Select an appropriate location for the device, e.g. a dry, fl at,
non-slip surface on which the device can be easily operated.
• Make sure that the device is adequately ventilated!
• Connect the loudspeakers to the back of the music centre to
the sockets market „Speaker R and L" (20).
• Insert the plug into a properly installed 230 V, 50 Hz power
socket. Please ensure that the mains voltage corresponds to
the information on the type plate.
• The stored time is lost as soon as the power is disconnec-
ted.
• Before initial use remove any protective foil on the mirror
lens.
Setting the Time
1. Press the TIME button (2). The words „24 HOUR" appear in
the display.
2. Use the SKIP+ /SKIP-
between the 24 hour and 12 hour display. Press the TIME
button (2) to confi rm.
NOTE:
The following appears in the case of the 12 hour display
AM = in the morning, PM = in the afternoon/evening.
3. Press the SKIP+ /SKIP-
hours. Keep the button pressed down until the desired hour
is reached. Press the TIME button (2) to confi rm.
4. Press the SKIP+ /SKIP-
set the minutes. Keep the button pressed down until the
desired minutes are reached.
5. Press the TIME button (2) again to store the time. TIME ON
appears for a few seconds in the display (see the TIMER
section).
50
05-MC 4412 AEG 50
Remote Control Batteries (not supplied)
•
•
•
•
CD deck transport protection
Please open the CD compartment (11) by pressing the OPEN/
CLOSE (open) button (12). Remove the transport protection
from the CD player if present before use.
Switching on (ON)
Turn the device on with the POWER ON/OFF switch on the back
of the device.
Switching off (OFF)
In order to turn the device completely off, turn the POWER
ON/OFF switch on the back of the device to „OFF".
POWER / „ " (4/12)
buttons (8/4) to choose
Switch the device to the standby mode with the POWER /„ "
button (the time is displayed). If this button is pressed once
more, the device switches on again.
Volume (5/10)
This is used to set the individual volume. The letters „VOL" and a
buttons (8/4) to set the
fi gure appear in the display (13). This corresponds to the volume
that has been set as far as „VOL MAX" or „VOL 00".
buttons (8/4) in order to
Please use headphones with a 3.5 mm stereo jack plug; these
should be inserted into the headphone socket. The loudspea-
kers are then switched off.
Open the lid of the battery compartment on the back of the
remote control.
Insert 2 batteries of type R03 „AAA" 1,5 V. Ensure that the
polarity is correct (see the fl oor of the battery compartment)!
If the remote control is not used for a prolonged period,
remove the batteries in order to prevent battery acid leaking.
Different battery types or new and used batteries must not
be used together.
CAUTION:
Batteries are not to be disposed of together with domestic
wastes. Dispose of the used batteries at the relevant collection
bin or at your dealer's.
WARNING:
Do not expose the batteries to high temperatures or direct
sunlight. Never throw batteries into the fi re. There is a danger
of explosion!
General Operation
NOTE:
Some keys are to be found both on the device itself and
on the remote control. Keys with the same designation
have the same function.
Headphone Socket (1)
18.06.2007, 11:56:55 Uhr